Robco Expert

OVER GREASING KILLS BEARINGS  by: Red Ops / Robco ·      Overfilling bearings with grease is the most common cause of bearing failures. ·      Too much grease in the cavity/bearing will cause more friction to run the bearing and that will result in an increased temperature to levels above the drop point of the grease: oxidation will occur and both the grease and bearing will prematurely fail! ·      Follow the instructions of the bearing manufacturer for greasing quantities as per bearing type and size. ·      Take into consideration the environment, temperature and operating hours.   OVER GREASED BEARINGS PROPERLY GREASED BEARINGS

Is there a rule of thumb to measure the proper amount of cooling water leakage , when using braided packing on rotary equipment (ex: pumps, agitators, mixers, etc.) ?  Jocelyn Vachon - VP B.Dev / Product Specialist In order for braided compression packing to seal and work properly on a dynamic equipment, water is injected through a flush line and distributed inside the stuffing box by a lantern ring. A small amount of this water will therefore leak out from the stuffing box.  The objective is twofold : A positive pressure of clean water has to be created inside the stuffing box, to prevent process fluid from entering the stuffing box To minimize frictional heat, by creating a hydrodynamic lubricating film between the stationary packing rings and the rotating shaft. This is a balancing act between how much compression is exerted on the packing rings set, to reduce to a minimum process fluid leakage versus limiting frictional heat. A...