Robco Expert

  ASME PCC1-2019 : technical notes about sealing performance Lotfi Grine, Eng. – Product Specialist at Robco   In the following technical notes, you will find valuable technical extracts from the ASME PCC1 2019 ( bolted flange joint assembly (BFJA) guidelines) to help better understand sealing behaviour and produce a positive seal. - Calculating Target Torque Values are based on the root area. The root areas are based on coarse-thread series for sizes 1 in. and smaller with 8-pitch thread series for sizes 1 1/8  in. and larger (Section H). - The major long-term value of coated bolts is to protect against corrosion of the exposed threads and to minimize break-out and nut-removal torque, thereby promoting ease of joint disassembly (Section 7). - Section VIII, Division 1 of the ASME Boiler and Pressure Vessel Code requires that nuts engage the threads for the full depth of the nut (Section 8.2).   - Start-up re-torque is performed when the temperature of ...

Junction with leak problem, Should I suspect the fastener device...? Jocelyn Vachon - VP Busines development - Robco Uneven Bolt Stress. An incorrect bolt-up procedure or cramped working conditions near the flange can leave some bolts loose while others are overtightened and crush the gasket. This can cause in-service leaks, especially in high temperature services when the heavily loaded bolts relax. in order to close the micropores inside the gasket itself and to fill in the unevenness at the flange facing - gasket interface, the assembly bolt load should be calculated according to the ASME Code. Every bolt has a correct torque/tension elasticity range and a properly tensioned bolt works at its optimum efficiency. If the tension is too low, the nut could vibrate or work loose and if the tension is too high (overstretched), the bolt may yield. That being said, we strongly encourage you to Choose the proper fastener device (Bolts, nuts and washers) for example use a hardened washe...